User guide

13 Instruction mode
RS 485:
 During input „Id 00“(function RS1 12, see chapter 12.12) the instruction format is
the same as with RS232.
 During input "ID 01-99“ "@ID „must be placed in front of the remote control
command, so that the respective scale reacts to the instruction; e. g. to set the
scale to zero with ID 99 the instruction must be sent to "@99MZ“ followed by the
control characters <CR><LF>.
Orders:
MZ Zeroing
MT Taring
MG Display gross weight
MN Indicate net weight
CT Delete tare
SC Continuous data output
SA Automatic data output
SO Instruction mode
% Stop continuous data output and start instruction mode.
UA* Switch over to the first weighing unit.
UB* Switch over to the second weighing unit*
UC* Switch over to the third weighing unit*
UD* Switch over to the forth weighing unit*
UE* Switch over to the fifth weighing unit*
UF* Switch over to the sixth weighing unit*
RW Send current weight value
RG Send gross weight
RN Send net weight
RT Send tare weight
RB Send the display value without status
RH Send gross weight without status
RI Send net weight without status
68 KXS/KXG-TM-BA_IA-e-1420