Operation Manual

61
Using simultaneously a fan, or a humidifier may cause the
flame to become slightly pink. This is normal. Never touch
the automatic ignition device when the heater is in use. By
lowering it you will make the flame rise if you push it too
strongly, you may damage the lighting filament or even
break it.
Adjusting the height of the flamme
Combustion can be optimized within a range of 10% by adjusting the height of the flame
(see hereafter).
Go up a little the button of adjustment to decrease the combustion.
Bad combustion Good combustion Bad combustion
Insufficient heating of the
upper part of the system.
Check the quality of the
fuel and the estate of the
wick
If despite the regulation, the flame is too high or if the heater unevenly (its colour is not
uniform), take the lever on the combustion cylinder and shake it gently once or twice, go
up the lever for the height of the wick. If the problem subsists, stop the heater and contact
your retailer.
If you continue using your heater with bad combustion, soot and/or CO emission will
result.
Flame is dangerously
high. Go up the lever