Operation Manual

Menu
124 KETRON • AUDYA
▀
OUTPUT ASSIGN
• By pressing the F5 button from the main page
of the MENU, you can access to the OUTPUT
ASSIGN screen where you can make the routing
settings of the internal sources to the outputs on
the rear (Main Stereo and separate outputs), as
shown in Figure 320.
The options are the following:
F1–Out3&4: 3 and 4 outputs.
F2– Out1&2 Drum: 1 and 2 outputs for the drum
and the percussive instruments.
F3– Out1&2: 1 and 2 outputs for the right hand, all
the drums and MIDI1.
Out3&4
By using the CURSOR
§ ¶
buttons or the DATA/
VALUE wheel you can select the source to send to
the 3 and 4 outputs.
The internal sources interne are the following:
Wave 1/2, A.Drum
MP3-2 (SFX)
MP3-1
Voicetron
Drawbars
Bass
Lower
Chords
By using the CURSOR
Ó
Á buttons you can select
the source one by one, and set the output destination,
choosing from Main Stereo or Main + 3&4.
By using the button USER 5 (SAVE) you can store up
to 5 outputs Presets. Select a Preset with the F6-F10
buttons and press the USER 5 button (SAVE).
Out1&2 Drum
By using the CURSOR
§ ¶
buttons or the DATA/
VALUE wheel, you can select the percussive
instrument of the drum to output (Figure 321). The
percussive instruments are the following:
KICK
SNARE
HI-HAT
CYMBAL
TOM
RIMSHOT
LATIN
CLAP
Once selected the percussive instrument, you can set
the output with the CURSOR
Ó
Á buttons, choosing
between Main Stereo or 1&2 Stereo.
Out1&2
By using the CURSOR
§ ¶
buttons or the DATA/
VALUE wheel, you can select the internal source to
send to the output 1 and 2 (Figure 322). The internal
sources are the following:
Right
All Drums
MIDI 1
2nd VOICE
Once selected the source, you can set the output
destination with the CURSOR
Ó
Á buttons,
choosing between Main Stereo or 1&2 Stereo.
Figure 321
Figure 322
NOTE
By pressing the USER 1 button you can toggle the 1&2
Stereo and the 1&2 Mono output, as shown by the
arrow on Figure 323.
Figure 320