Operation Manual

OTHER STYLE FUNCTIONS

• Highlight “Pianist” and press Enter to select this (within

4 seconds). This allows the MIDJAY to recognize chords

through the entire Keyboard and ignore the Split point (if

any was set).

• Highlight “Manual Bass” and press Enter to select this

(within 4 seconds). This allows real Bass notes to be

played on the Left of the Split point of the Keyboard.

• Highlight “Bass Lowest” and press Enter to select this

(within 4 seconds). This allows MIDJAY to play just the

lowest note that constitutes the Bass phrase.

• Highlight “Balance” and use the Alpha Dial wheel to change its value. This value controls the value of the

Left side, i.e. the Arranger with respect to the Right side... where you play the Lead notes.

• Highlight “Lower Off” and press Enter to select this (within 4 seconds). This permits you to turn OFF the

manual Lower Voices associated with each Style.

EDITING STYLES

It is possible ne-tune and edit certain parameters of the Style

to your perfection. To do so, while the Style light is ON, select

the Style you want to edit (select the Style as shown above).

1. Press the Edit button to display the “Style Edit” screen that

shows all the editable parameters: the Volume, the Program

Change, the Pan/Pot, and the amount of Reverb and

Chous/Delay (SFX). On the Lower parameters, it is possible

to edit Volume, Program Change and Eighth (+/- 24).

2. Highlight “Parameter” and press the Enter button to select it (within 4 seconds). The editable Parameters

of the Style will be displayed on the next page. Use the Cursor keys to highlight the parameter you wish to

change and change the corresponding value using the Alpha Dial wheel. To zero out any value, press the

Enter button once selected. The Enter button can be pressed once more to restore the initial value.

3. To save these setting such that when next this Style is used, the new settings will automatically be

associated with this Style, from this Edit screen, press the Save button. You can now either save this Style

with the same Style name or re-name this Style to distinguish it from the initial Factory Style. “Saving File.

Wait please...” will be displayed while the File is being saved on the Hard Disk. This will now become a Disk

Style that can be instantly loaded from Disk.

4. To play this Style back (or any other Style that resides on Disk), press the Master Folder Style button. If

the root directory “C:\Styles” is not displayed on the top of the screen, press Exit until it is displayed.

5. You can now select any of the Styles you have in the Hard Disk and press Enter to instantly load it. The

Style is now ready for use (just like any of the internal Style).

CONTROLING THE STYLES FROM AN EXTERNAL MIDI CONTROLLER

The Styles can be recalled via MIDI if saved into a “Registration”.

A single Style, together with a corresponding Voice set up, can be associated with a single Registration and

saved on Disk.

After programming the Registrations this is the procedure to load it:

1. The MIDJAY must be on “Keyboard Mode”.

2. Enter the MIDI Menu and select the MIDI Channel Receive for Registration.

3. Press Registration button.