Operation Manual

VEGA
25
SAVING AND LOADING A PROGRAM
Once a Program has been modified or programmed, it must be saved in the memory or on disk for future recall or use. It is advisable to save
your favourite programs in RAM due to the fact that these are immediately available and can be recalled instantaneously. Programs which reside
in DISK have to be loaded into RAM prior to being used.
PROCEED AS FOLLOWS TO SAVE A SINGLE PROGRAM IN RAM
●
Select the program to be saved.
●
Access the Edit Program environment by pressing the function push button relative to the Program selected once again or from the main
page of the display by pressing F8 Edit Program.
●
Press SAVE/ENTER. The page that appears will show the destination memory location that can be modified by entering the number with
the STYLE push-buttons and the name to be assigned to the Program using the keys of the keyboard.
●
Confirm that the program is to be saved using F10 Save. Press F5 Escape to annul the operation.
PROCEED AS FOLLOWS TO SAVE A SINGLE PROGRAM ON DISK
●
Press DISK and select the destination disk on which the Program is to be saved, using the PAGE +/- push buttons. If you have selected the
hard disk, also select the destination folder.
●
Repeat the procedure given for saving in RAM up to the SAVE/ENTER page.
●
Enable saving on disk using F9 Save To Disk.
●
Confirm the procedure using F10 Exec, or cancel using F5 Escape.
●
When the Program to be saved on disk has the same name as a Program that already exists, the display shows three options, namely:
F5 Name this is used to give a new name to the Program and then to confirm that it is to be saved using F10 Exec
10 Overwrite this enables saving by cancelling and overwriting the Program that already exists on disk.
F4 Dir this displays the disk directory enabling the user to control the names that already exist. The user can only return to the saving
on disk page from the directory by exiting (pressing EXIT) and therefore repeating the procedure just described. In this case all the
modifications made to the Program will be stored in volatile memory.
PROCEED AS FOLLOWS TO LOAD A SINGLE PROGRAM FROM DISK
●
Press the DISK push button.
●
Choose from which disk the program is to be loaded using the PAGE +/- push buttons.
●
Select the type of file to be loaded using F5 File Choice.
●
Select F2 Single Program or F7 Program to load a complete bank.
●
Type in the number of the folder in which the Single Programs to be loaded are stored using the numeric keypad (STYLES push buttons).
●
Select the Program using the VALUE +/- push buttons.
●
Press F2 Load.
Program and One Touch Voices