Operation Manual

VEGA

F7 Program Change Tx:

For each section you can establish whether the Program Change message associated with the Voice in use is also to

be transmitted to MIDI Out. The transmission function is enabled or disabled using the F10 Select push button. The

2nd/Prog section refers to the Second Voice and to the Program memory, processed as a Single Voice. The Voice sec-

tions 1, 2, 3 and 4 refer to the single Voices of a Program.

Program Change Rx:

The same as F7 Program Change TX, but dedicated to the Program Changes received on MIDI In 2 (Keyboard).

F9 Clock SoftThru:

The VEGA can receive and transmit the MIDI Clock that is used to synchronise the Arranger, Song Play and the

Sequencer with other external units. The function of the START push button depends on these settings. The parame-

ters available are selected using the CURSOR +/- push buttons and are enabled using F10 Select. They are:

Clock Out: When this function is enabled, the VEGA sends the MIDI Clock to MIDI Out and therefore it can con-

trol the tempo values during reproduction in external sequencers.

Clock In: When enabled, the reproduction controls of the VEGA (including tempo) depend on MIDI Clock inputs

received on MIDI In and not on the push buttons on the control panel.

Soft Thru 1: When enabled, the MIDI Clock received on MIDI In 1 GM is sent back to MIDI Out.

Soft Thru 2: When enabled the MIDI Clock received on MIDI In 2 Keyboard is sent back to MIDI Out

F10 Utility:

This is the only menu that is to be called up from the initial page of the MIDI menu and is used to access some set-

tings dedicated to the MIDI ports. The parameters (whose values of are called up by pressing the relative function push

button repeatedly) are:

F1 MIDI In 1: This is used to modify the initial setting of the MIDI port from GM to Keyboard.

MIDI