Operation Manual

select the event type you want to insert. Use the Cursor <> buttons to move around the various event

fields to edit parameters. Press F10 to confirm the operation, or F5 to cancel it.

EDIT Delete: This function deletes a single event; press F4 (DELETE) to open the window (non

editable) containing the selected event. If you confirm by pressing F10, the event will be deleted.

Press F5 to cancel the operation and the event will not be deleted.

EDIT (seconda pagina):

Press Page > to access the second edit page. Two

important functions can be accessed from the second

page; FADER and LOGICAL.

EDIT FADER: This function allows you to insert controls

continuously so that you can give expression to the

sequence. This function is useful if, for example: You want

to obtain a crescendo or fade an orchestra instrument. You

want to move the Pan-pot continuously Left-center-Right to simulate movement. You want to change the

filter of an instrument gradually (Cut-Off) in order to obtain, for e.g., effects such as Wha-Wha.

Let us make an example so that the use of this function becomes clearer: Say you want to obtain a

volume crescendo from 1 to 96 and then a decrescendo from 96 to 20. Let us suppose that the

crescendo should go from bar 31 to bar 33; the decrescendo from bar 33 to bar 36. Use the

Cursor <> buttons to access the various function fields.

a) Use the Value -/+ buttons to select “VOLUME” from the EVENT box.

b) In the three position boxes (1st POSIT, 2nd POSIT, 3rd POSIT) enter the following settings:

Position [31 1 1]. Crescendo start position

Position [33 1 1]. Decrescendo start position (in this position the volume reaches its

maximum value)

Position [36 1 1]. Fading end position.

c) In the three Value boxes (1st VALUE, 2nd VALUE, 3rd VALUE) enter the following settings:

VALUE: 1. Crescendo start volume value.

VALUE: 96. Crescendo end and decrescendo start volume value.

VALUE: 20. Decrescendo end value.

Note. If you want to perform only one crescendo or decrescendo, press the Value -/+ buttons

together and set the 3rd VALUE field on Off. Interposed arrows between the VALUE fields indi-

cate whether you are performing a crescendo or a decrescendo.

a) In the STEP box, select the number of steps for which each volume crescendo or decrescendo

is to take place. Use the Value -/+ buttons to change the value. In the REPEAT box, select the

number of bars for which the entire FADER cycle is to be repeated. If, for example, you use the

Value -/+ buttons to enter value 2, the volume crescendo and decrescendo will take place for two

consecutive bars.

b) Press F10(Execute) to confirm the operation. Press F5(Escape) to return to the EDIT page EDIT.

EDIT Logical: Press F4 to access the LOGICAL function. This is a quite complicated but powerful

function. It allows you to edit in a complete manner groups of events of the running track. Let us

start by describing the various fields making up the page (use the Cursor <> buttons to access them).