Operation Manual

XD9-XD3

●

Once the voice has been selected, use the CURSOR +/- buttons to determine if the modification has to refer to all the Arranger parts (Global

mode) or only to the one currently in use (Single mode). The Global/Single parameter can be shown on the bottom of the display or above

the box where the title of the Style in use is shown. Live Drums are excluded.

The sound choices made in Global or in Single mode applies also to the two Lower parts and the Drum 1 track. In the latter case, after having

selected the Drum 1 track, the VOICES push buttons call up groups of preset Drum Sets and User Drum Sets. It is not possible to modify the

Drum Set of Drum 2 because this exploits a Live Drum and particular settings which would thwart the modification.

The Style modified as described above must be saved if you do not want to lose the settings. Further details will be given later on in this sec-

tion.

LOWER TRANSPOSITION 1 & 2

Select the part pressing F4 Lower 1 or F5 Lower 2. On the display the present Arranger part and the transposition of the selected part is dis-

played. Set the transposition with the CURSOR +/- push buttons within a few seconds; otherwise the Lower transposition parameter disappears

and the CURSOR +/- push buttons take over the function to transpose the entire Style and keyboard.

Repeat the operation for the other Style parts.

ARRANGE VIEW: FIRST PAGE

Further to modifying the volume for the single tracks and the Lower parts, the XD9 allows you to activate the Mute function on a single track.

This setting will remain stored also for the next Styles selected. In order to activate the Mute function on a track, select the track pressing the

relevant function button and then press both VALUE +/- buttons at the same time. If you wish to restore the initial volume value, press one of

the two VALUE +/- push buttons. In order to modify the volume of a track or of a part, select it with the relevant function push button. Modify

the volume value using the VALUE +/- push buttons. The Mute function is activated only by pressing both VALUE +/- push buttons at the same

time, and not by setting the value to zero. For the Lower parts only, you may establish a different volume value for the single Arranger parts.

ARRANGE VIEW: SECOND PAGE

The reverb quantity of each track (and for the Lower parts) remains unvaried for all Style parts. To carry out any modification, select the track

or the part pressing the relevant function button. Modify the value pressing the VALUE +/- buttons.

ARRANGE VIEW: THIRD PAGE

Arranger