Operation Manual

XD9-XD3
69
The XD9 does not only choose the algorithm to be assigned to the DSPs but it also allows its substantial modification and saving in dedicated
memories. To modify an algorithm - first of all, it must be selected among Chorus, Delay and Distorsion, simply by pressing the function push
button and choosing the algorithm. Without doing anything else at this stage press F10 Edit to access the menu.
No matter what algorithm is to be modified, the Edit page shows some fixed parameters as discussed:
FF44 DDeeffaauulltt
: This resets the parameters of the algorithm at their original values.
FF55 EEssccaappee
: This returns to the Effects menu.
FF88 SSoouurrccee
: This indicates the current algorithm selected to be modified, however by pressing function push button F8 several times, a
different algorithm can be selected.
FF99 DDeessttiinnaattiioonn
: This specifies the destination memory for the algorithm modified. It is selected by pressing the function push button F9
repeatedly.
FF1100 SSaavvee
: This confirms and saves the parameters modified in the memory selected using F9 Destination.
The single parameters to be modified are shown in the middle of the display that are selected using the CURSOR +/- push buttons and are mod-
ified using the VALUE +/- push buttons.
PARAMETERS FOR CHORUS ALGORITHMS
LLeevveell
: This is the level of the signal.
DDeellaayy
: This is the length of the delay.
FFeeeeddbbaacckk
: This is the repetition degree of the Delay.
RRaattee
: This is the modulation speed.
DDeepptthh
: This is the modulation intensity.
PARAMETERS FOR DELAY ALGORITHMS
VVoolluummee CCeenntteerr
: This is the level of the signal repeated in the centre.
VVoolluummee LLeefftt
: This is the level of the signal repeated to the left.
VVoolluummee RRiigghhtt
: This is the level of the signal repeated to the right.
DDeellaayy CCeenntteerr
: This is the delay speed for repeating the signal in the centre.
DDeellaayy LLeefftt
: As above but for the signal to the left.
DDeellaayy RRiigghhtt
: As above but for the signal to the right.
FFeeeeddbbaacckk
: This is the signal regeneration degree.
FFiilltteerr
: This is the LPF filter to cut out the higher frequencies.
PARAMETERS FOR DISTORSOR ALGORITHMS
LLeevveell
: This is the level of the signal.
TToonnee
: This is the timbre variation degree.
RReessoonnaannccee
: This is the accentuation of the frequencies of the distorted timbre.
Effects