Operation Manual

XD9-XD3

CALLING UP AND SAVING A REGISTER OF THE SINGLE REGISTRATION GROUP

The call-up function of a Single Registration is enabled by setting to Single the F7 Registration Mode parameter in the F3 Utility menu. Then

enter the number of the Single Registration/Register contained on the floppy disk or in the folder currently selected on the hard disk to call it

up. A Folder or a Floppy Disk may store up to a maximum of 999 Single Registrations, the numbering of which is automatically attributed accord-

ing to the time order in which the file is created, whereas the file will always be displayed in alphabetical order.

In both cases it is always possible to display the list of Single Registrations stored in the Folder using the DISK menu. From this page you can

find the progressive number attributed to the Single Registrations when the file is created or you can select the Single Registration to be loaded

directly using the VALUE +/-, F10 Select and F2 Load push buttons.

Note: The Single Registration cannot be called up using the numeric keypad in the Disk environment; therefore the Single Registration is either

selected using the normal procedures required in the Disk environment or you return to the main page of the display using the EXIT push but-

ton and enter the number of the desired Registration with REG. enabled.

To save a Single Registration on disk (.SRG extension) you must first select the target folder on the hard disk or the floppy disk.

●

Press SAVE/ENTER.

●

Select F1 Registr.

●

From the page that follows enter the name of the Single Registration using the keyboard keys and the CURSOR +/- push buttons.

●

Confirm using F10 Save or cancel using F5 Escape.

AUTOMATICALLY LOADING THE TEXT FILE AND MIDI FILE USING REGISTRATIONS

This function is one of the most powerful and useful functions of the XD9. It is used to avoid lots of procedures to load the file required when

playing live. There is no operational difference between a Registration of the Block Registrations and a Single Registration.

To automatically load a text file with .TXT extension or a Midi file with .MID extension all that is needed is for the name of the Registration to

match that of the .TXT or .MID file. The Midi file will be available by enabling SONG PLAY and then by pressing START.

DEFINING WHICH PARAMETERS WILL BE CONTROLLED BY THE REGISTRATION

It could prove useful to prevent the Registrations from saving or calling up one or a number of parameters which they control. For example, you

can prevent just the Vocal Sets or the assignment of the effects from being called up. Each single parameter can be detached from the

Registration. These settings are achieved in the following manner:

●

From the main page of the display press F3 Utility.

●

Select F6 Registration Menu

The page displayed shows the parameters in the middle, grouped per areas to which they belong, called up using the function push buttons. For

F3 Keyb&Util and F5 Arrange a number of parameter pages are foreseen that are called up by pressing the same function push button

again. The parameters in the middle of the display are accessed using the CURSOR +/- push buttons whereas their enabling status is modified

from F10 Select. The first time you access the F6 Registration Menu the Global parameters are shown. Below is the description.

F1 Global: This is used to disable the control of all the parameters related to MIDI, Left Control, Arrange Mode, Drum Mixer, Utility, Play

Control, Effect&Micro, 2nd Voice, Global Transpose and Left Level.

Registrations