Operation Manual

THE PARAMETERS OF THE MIDI MENU
F1 Channel Transmit:
This is used to associate a MIDI transmitting channel on the MIDI OUT to each section. The following functions
are also available:
F4: this switches between the Channel Transmit page and Channel Receive page.
F5 Escape: This returns to the initial page of the MIDI menu.
F10 MIDI Setup: This calls up the settings already put in order and saved to use the XD9 via MIDI.
The MIDI Set-up currently selected is also that where the settings will be saved using the SAVE/ENTER push button.
F2 Channel Receive: This is used to associate a MIDI receiving channel on MIDI In 2 (Keyboard) to each section. The parameters are
the same as F1 Channel Transmit.
F3 Transpose Transmit:
The value for each single section identifies the number of transposition semitones applied to the notes trans-
mitted on the MIDI Out.
F4 Transpose Receive: The value of each section identifies the number of transposition semitones applied to the notes received on the
MIDI In 2 (Keyboard).
F5 Filter Tx:
Valid for all the sections, the MIDI filters being transmitted are used to enable or disable the transmission of
some MIDI messages such as the Pitch Bend, some Control Changes and exclusive system messages. The type
of message to be filtered is selected using the CURSOR +/- push buttons and is enabled or disabled using the
F10 Select push button. The filter is enabled when the symbol “*” appears next to the MIDI message.
F6 Filter RX: The same as F5 Filter Tx, but dedicated to the MIDI messages received on MIDI In 2 (Keyboard).
XD9-XD3
82
MIDI