Operation Manual

Change of power profiles

If the power is changed during program run, the change

becomes effective to the right of the blinking column. The

columns to the left of it show the rendered performance

values and remain unchanged.

Change from speed-independent to speed-

dependent operation

(running ergometer)

During training press “SET”. A change from speed-depen-

dent to speed-independent operation takes place.

Display: both arrows under RPM

Pressing “SET” again switches operation back to speed-

independent.

The change from speed-dependent to speed-independent

operation is only possible in the programs “Count Up”

and “Count Down”. The ERGORACER always starts

speed-independently. If training is interrupted, operation

switches back to speed-independent.

Interruption or end of training

For less than 10 pedal revolutions/min or pressing

“RECOVERY”, the electronic equipment recognizes an

interruption of the training. The training data achieved are

displayed. Speed, power, revolutions and pulse are repre-

sented as average values with the Ø symbol.

With “Plus” or “Minus” you can change into the current

display.

The training data are displayed for 4 minutes. If during

this period no key is pressed and no training takes place,

the electronic equipment switches into the snooze mode

with room temperature display (display of the room tempe-

rature only SD4-9).

Resumption of training

When continuing the training within 4 minutes, the last

values are further counted or counted down.

Note:

Training and Operating Instructions