User Manual

Brewer Exterior
Keep your Keurig® brewer looking its
best by cleaning the exterior from
time to time. Just clean with a damp,
soapy, lint-free, non-abrasive cloth.
Never immerse the brewer in water or
other liquids.
Drip Tray
The drip tray can accumulate up to
8 ounces of overflow and should be
emptied and cleaned occasionally. To
remove, slide it toward you, keeping
it level to avoid spilling. Clean in
dishwasher (top rack only) or rinse
and clean with a damp, soapy, lint-
free, non-abrasive cloth.
Water Reservoir & Reservoir Lid
The water reservoir lid and water
reservoir should be periodically
cleaned with a damp, soapy, non-
abrasive cloth and rinsed thoroughly.
The water reservoir lid and water
reservoir should not be put into the
dishwasher. Do not dry the inside of
the water reservoir with a cloth as lint
may remain.
To clean the filter screen at the base
of your water reservoir, empty the
water reservoir and follow one or all
of the following procedures:
• Rinse the filter screen with the strong force of water from
your faucet.
• If you have a sprayer, aim the water spray at the filter screen.
• Fill the water reservoir with approximately two inches of
clean water and agitate (shake) the water reservoir. Empty
the water reservoir, fill with clean water, and return it to the
brewer. If needed, repeat above procedures.
CAUTION: Please rinse the water reservoir thoroughly after cleaning. This will ensure that no cleaners or cleaning
solutions remain in this area as they may contaminate the water supply in the brewer.
Caring for your Brewer
K-Cup® Pod Holder Assembly
To remove the K-Cup® pod holder from
the brewer, lift the handle and grasp
the top of the K-Cup® pod holder
with one hand while pushing up on
the bottom of the K-Cup® pod holder
from underneath with the other until
it releases. After cleaning, align the
K-Cup® pod holder with the opening
using the two front ribs as a guide
and snap into place from the top.
CAUTION: There are sharp needles that puncture the K-Cup® pod above the K-Cup® pod holder and in the
bottom of the K-Cup® pod holder. To avoid risk of injury, do not put your fingers in the K-Cup® pod holder.
Funnel
The funnel can be removed from the
K-Cup® pod holder by pulling on it until
it pops off. To replace it, just snap it
back onto the K-Cup® pod holder.
Exit Needle
Remove the pod holder assembly and
detach the funnel. Locate the exit
needle on the inside bottom of the
K-Cup® pod holder. Insert a straightened
paper clip into the exit needle to loosen
the clog and push it out.
Entrance Needle
Lift the brewer handle and locate the entrance needle on the
underside of the lid. To clean both holes in the needle, hold
the brewer handle in the upward position and with your other
hand, carefully insert a straightened paper clip into both
holes. Gently move it around to loosen any coffee grounds.
Lower the handle completely and run two water-only brew
cycles. Do not insert a K-Cup® pod.
TIP: Refer to www.Keurig.com/support for video instructions on cleaning the entrance/exit needles.
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning.