User Guide

Get the most from your
new Keurig
®
brewer
K-CLASSIC
™
Use & Care Guide
P/N | Pièce n
o
| Pieza n.
o
DC0000001086 REV A 06/17
A. Water Reservoir Lid
B. MAX FILL Line
C. Water Reservoir
D. Vent
E. Water Reservoir
Lock Tab Slots
F. Power Cord
G. Handle
H. Lid
I. K-Cup® Pod Holder
(I and J are the K-Cup®
Pod Holder Assembly)
J. Funnel
K. K-Cup® Pod
Assembly Housing
L. Drip Tray Plate
M. Drip Tray
N. Drip Tray Base
For replacement parts, please visit www.Keurig.com
B
A
C
E
G
H
I
J
K
L
M
N
F
D
Keurig Green Mountain, Inc.
33 Coffee Lane
Waterbury, VT 05676
1.866.901.BREW (2739)
K-CLASSIC
™
BREWER
KEURIG.COM/NEW
Plug & Place
Remove packing tape from
brewer and plug into a grounded
outlet.
Place a large mug (10 oz.
minimum) on the drip tray plate.
Rinse & Fill
Remove the water reservoir lid, then lift
the reservoir straight up to remove it.
If you have a Keurig® Water Filter,
install it now. Refer to your Water
Filter Starter Kit for instructions.
Rinse reservoir with fresh water and
fill to the MAX FILL line.
Replace water reservoir, making sure the
lock tabs engage with the brewer. Replace lid.
NOTE: Do not use distilled water.
Power On
Press power button — the green power
light will illuminate.
The brewer will automatically begin
heating the water. The red heating light
will illuminate for about 4 minutes. Once
the heating light goes off and the brew
buttons illuminate, the brewer is ready.
Lift & Lower
Lift and lower the handle. Do not
insert a K-Cup® pod. The three brew
buttons will blink.
Press the small cup button to start
a cleansing brew. Pour the hot water
into the sink.
The one-time setup process is now
complete and you are ready to brew!
Lift & Insert
Lift the handle and place a K-Cup®
pod in the K-Cup® pod holder. Lower
the handle completely to close the lid.
Do not remove the foil lid on the
K-Cup® pod.
High Altitude Brewing: While holding
the brewer handle up, push down
slowly on the K-Cup® pod in the pod holder until the
bottom of the K-Cup® pod is punctured by the exit needle.
Place Mug
Place a mug on the drip tray
plate. If using a travel mug,
remove the drip tray and place
the mug on the drip tray base.
NOTE: Between brew cycles, the brewer may take 15
seconds to reheat during which time the red heating light
may be illuminated.
Brew & Enjoy
Select your brew size. The button will
remain illuminated while brewing — about
1 minute. Brewing ends with a burst of air.
Lift the handle and dispose of the used
K-Cup® pod. The brewer will be ready to
brew another cup in less than a minute.
NOTE: After 60 seconds, the brew buttons will be disabled. To re-activate,
lift and lower the handle completely.
CAUTION: While brewing, there is extremely hot water in the K-Cup® pod
holder. To avoid injury, do not lift the handle during the brewing process.
Brewer Features
Auto Off sets the brewer
to turn off 2 hours after
the last brew for energy
savings.
To enable, press the black
Auto Off button and the
green light will illuminate.
To disable, press the Auto
Off button again.
1
2
3 4
4
Before You Brew
Brew Your First Cup
5
6
7
Fully experience the benefits that come with your new Keurig® brewer at
your favorite coffees with
our customized taste quiz and get
personalized recommendations
your new Keurig® brewer
to activate your warranty and
receive a special savings offer
Small Cup
6 oz.
Large Mug
10 oz.
Small Mug
8 oz.