P1 201309003 KER755_K10.pdf 4C( CMYK) ZB2319 2013.09.
P2 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Important Safeguards When using electrical appliances, basic safety precautions should be followed, including the following: 1. Read all instructions before using. 2. Do not touch hot surfaces. Use handles and knobs when available. 3. This appliance must be properly installed and located in accordance with these instructions before it is used. 4.
P3 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 WARNING Keep all plastic bags away from children. CAUTION: There are two sharp needles that puncture the K-Cup® pack, one above the K-Cup® Pack Holder and the other in the bottom of the K-Cup® Pack Holder. To avoid risk of injury, do not put your fingers in the K-Cup® Pack Assembly Housing. WARNING THIS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD, WHICH IS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
P4 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 SECTION 1 Table of Contents Brewer Overview A Water Level Guide KEURIG® GOURMET SINGLE CUP HOME BREWING SYSTEM K10 MINI Plus Brewer — Using Your Brewer B Handle Section 1—Brewer Overview........................................................... 4 C K-Cup® Pack Holder Assembly Section 2 —Helpful Hints.................................................................. 6 D K-Cup® Pack Holder Section 3—Buttons & Indicators..........................
P5 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 J A K B L M D C N E F O G H I P For replacement parts, please visit www.keurig.
P6 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 section 2 Helpful Hints 1. Plug Power Cord into an independent, grounded outlet. If the electric circuit is overloaded with other appliances, your brewer may not function properly. 2. Initial cleansing brew. Before you make your first beverage, perform an initial cleansing brew without inserting a K-Cup® pack. 3. One cup at a time. Your brewer makes one fresh beverage at a time. You will need to add fresh water each time you brew.
P7 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 section 3 Buttons & Indicators Power Button (does not illuminate) Your Next Brew Press to turn the brewer power on and off. When the brewing process is complete, the Add Water Indicator light will appear. At this point you can begin making the next beverage, or you can power off.
P8 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Section 4 Set-Up & Operation Initial Cleansing & First Brew CAUTION: Two sharp needles are used to puncture the K-Cup® packs. One is above the K-Cup® Pack Holder and the other is in the bottom of the K-Cup® Pack Holder. To avoid risk of injury, do not put your fingers inside the K-Cup® Pack Assembly Housing. BREW BREW CAUTION: During the brewing process, the water gets extremely hot.
P9 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 For accurate measuring, do not fill if the Handle is up. In the down position it prevents water from entering the lower heating compartment. MAX 10 oz. 8 oz. 6 oz. MIN 2 Press the Power Button. The Add Water Indicator will flash blue. 3 4 Lift the Cold Water Reservoir Lid. The Power Button does not illuminate.
P10 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Section 4 Set-Up & Operation (continued) Let water fully drain into brewer 5 Sec before lowering the Handle. 5 Lift the Handle. Water starts to drain from the Cold Water Reservoir into the brewer. If you add more than 10 oz., excess water goes into the Drip Tray. DO NOT remove foil lid or puncture K-Cup® pack. 6 7 Place mug on the Drip Tray. 8 Insert the K-Cup® pack into the K-Cup® Pack Holder.
P11 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 2 Min 9 10 11 The BREW Button will flash blue. Press the BREW Button. The BREW Button will flash red to indicate that the water is heating. After about 2 minutes, the BREW Button will turn solid red when the beverage starts to dispense. Enjoy your beverage! Your brewer is ready to use again or you can power it off. ! CAUTION: Do not lift the Handle while brewing. As a safety feature, brewer automatically shuts off after 90 seconds.
P12 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 section 5 Cleaning & Maintenance Cleaning External Parts Cleaning the K-Cup® Pack Holder Assembly IMPORTANT: Make sure the brewer is unplugged before cleaning. IMPORTANT: Make sure the brewer is unplugged before cleaning. Regular cleaning of the brewer’s external components is recommended.
P13 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 2. Separate the Funnel from the K-Cup® Pack Holder by pulling it until it 4. To replace the Funnel, just snap it back into the K-Cup® snaps free (fig. 2). Pack Holder (fig. 4). 3. Clean the Exit Needle on the bottom of the K-Cup Pack Holder. Insert a paper clip (fig. 3) or similar tool from below if needle becomes clogged by coffee grinds. ® fig. 2 fig. fig. 4 3 5.
P14 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Section 5 Cleaning & Maintenance (continued) Cleaning the Cold Water Reservoir Emptying the Internal Hot Water Tank It is normal over time for discoloration, spotting or staining to appear in the Cold Water Reservoir. Results will vary depending on the mineral content of the water used but will not affect the operation of the brewer. However, be sure to clean the Cold Water Reservoir regularly to minimize build-up.
P15 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Storage • After 5 seconds, lower Handle and press the BREW button. • Once solution is dispensed, discard hot contents into sink. Empty the Internal Hot Water Tank and Cold Water Reservoir before storing. See page 14. Store your brewer in a safe, frost-free environment in an upright position. STEP 2: SECOND DESCALING SOLUTION RINSE • Repeat above process up until you press the BREW button.
P16 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 SECTION 6 Troubleshooting SITUATION SOLUTION Brewer does not have power BREW Button flashes red too long • • • • • • • Make sure the Power Button has been pressed. The Add Water Indicator should flash blue after pushing the Power Button. Note that the Power Button does not illuminate. During normal operation, the brewer will shut off when it is idle for longer than 90 seconds. Just press the Power Button to restart.
P17 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 SITUATION SOLUTION Brewer will not brew when used for the first time Brewer only brews a partial brew • Brewer may be cold or frozen. Let brewer rest at room temperature for at least 2 hours before powering on. • Make sure the brewer has power (see previous page). • • • • • Allow enough time for water in the Cold Water Reservoir to drain completely into the brewer. The Exit Needle may be clogged (see page 12).
P18 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 SECTION 7 Nor does this warranty cover damages caused by use of non Keurig Brewed® K-Cup® brand packs or accessories, services performed by anyone other than Keurig or its authorized service providers, use of parts other than genuine Keurig® parts, or external causes such as abuse, misuse, inappropriate power supply or acts of God.
P19 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06 Scan. Click. Call! Learn more and reach us quickly without leaving home. Scan here for videos about caring for your brewer! Have questions? We’re here to help! Scan this QR code with your smartphone for step-by-step videos on cleaning, descaling and more. Or if you prefer, you can watch the videos on your computer at bit.ly/NjTZ8W Keurig is committed to your satisfaction.
P20 201309003 KER755_K10.pdf 4C( CMYK) ZB2319 2013.09.06 To learn more about Keurig, visit www.keurig.com or call 1.866.901.BREW (2739) Keurig, Incorporated 55 Walkers Brook Drive Reading, MA 01867 holly-owned Keurig, Incorporated is a w subsidiary of Green Mountain Coffee Roasters, Inc. For Household Use Only Pat. www.GMCR.
