Owner's Manual

15
14
Storage 
Empty the Internal Hot Water Tank and Cold Water Reservoir before storing.
See page 14. Store your brewer in a safe, frost-free environment in an upright
position.
Storing the brewer in cold temperatures may cause any residual
condensation to freeze inside the brewer and could cause damage.
Before using your brewer after storage, wipe the Cold Water Reservoir with a
damp, non-abrasive lint-free cloth and run three (3) cleaning brews (without
K-Cup
®
packs). See page 8 for initial cleansing brew process.
Let brewer rest at room temperature for at least 2 hours before
powering on.
Storing the Power Cord 
Behind the brewer is a convenient
compartment to hold the Power Cord
during transport or storage (fig. 8).
Service
Beyond these recommended cleaning and maintenance procedures, this
brewer is not user serviceable. See page 18 for warranty guidelines. For
service, please refer to the Warranty section in this guide.
fig.
8
• After5seconds,lowerHandleandpresstheBREWbutton.
• Oncesolutionisdispensed,discardhotcontentsintosink.
STEP 2: SECOND DESCALING SOLUTION RINSE
• RepeataboveprocessupuntilyoupresstheBREWbutton.
• WhenBREWbuttonturnssolidred,poweroffasitstartstodispense.
• Letbrewerstandforatleast30minutes.
• Poweronthebrewer,liftandlowerHandle,thenpressBREWbutton.
• Discardthehotcontentsintosink.
STEP 3: FRESH WATER RINSE
• RepeatStep1(3times)–using10oz.offreshwatereachtime.
• YoumayneedtoperformadditionalFreshWaterRinsecyclesifyounotice
any residual taste.
NOTE: The cleaning action of Keurig
™
Descaling Solution may result in a foam
dispensed from the brewer. This is natural, as the solution is reacting with the
scale inside. For a brewer that is heavily scaled, the brewer may not fill
properly after the descaler is added. If this occurs, you may see only a small
or no output dispensed followed by the sound of air blowing out. If this occurs:
• Turnoffandunplugthebrewer.
• Plugthebrewerbackin,poweron,andrepeattheStep3FreshWater
Rinse cycle. The brewer should begin to function normally as the solution
is rinsed out and the scale is removed. If problem persists, allow brewer
to sit unplugged for at least 30 minutes before continuing with the rinse.
Visit us online for more information at www.keurig.com/descaling.
P15 201309003 KER755_K10.pdf 1C( K) ZB2319 2013.09.06