Manual

Chapter 6 PLC Link
104
6
6.1 PLC Link
The PLC link enables read data to be directly stored in the internal memory of a
PLC (programmable logic controller).
Since the BL-700 directly controls the PLC’s memory, no program is required for
data communication, resulting in a reduced number of programming steps.
As compared with the serial communication using a computer, the PLC link in-
volves the following limitations:
• The BL-700 settings cannot be changed because the PLC link cannot send a
command to the BL-700. However, the PLC link provides a reading control
address to start/end reading.
• The PLC link cannot start the test mode.
6.1.1 List of PLCs used for PLC link
KEYENCE (Built-in CPU port)
KV series KV-10/16/24/40/80
KV-300*
(Serial interface module)
KV-L2*
Mitsubishi (Built-in CPU port)
MELSEC-A series A2CCPU24
A2CCPU24-PRF
(Calculator link unit)
AJ71C24
AJ71C24-Sx
AJ71UC24
A0J2-C214-S1
A1SJ71(U)C24-R2/PRF/R4
OMRON (Built-in CPU port)
SYSMAC-C series C20H/28H/40H/60H
C200HS(CPU21/23/31/33)
C200HE(CPU42)
C200HG(CPU43/63)
C200HX(CPU44/64)
(High-order link unit)
C200H-LK201(-V1)
C500-LK203
C500-LK201-V1
C120-LK201-V1
C200H-LK202(-V1)
C120-LK202-V1
(Communication board)
C200HW-COM02
C200HW-COM03
C200HW-COM04
C200HW-COM05
C200HW-COM06
OMRON (Built-in CPU port)
SYSMAC-CQM1 series CQM1(CPU21/41/42/43/44)
OMRON (Built-in CPU port)
SYSMAC-CV series CV500
CV1000
CV-M1
(High-order link unit)
CV500-LK201
Note: KV-300 and KV-L2 are not available in Europe.