Manual

Appendices
142
Appendices
■ Comm Settings-1
Read mode ■ ■ Single Data send trigger ■ ■ After reading ■ ■ After trigger
OFF
■ ■ Multi 1 Double reading ( )
■ ■ Multi 2 prevention time
■ ■ Multi 3
Decode match count ( )
■ ■ Decode count ■■ Scan count
(available only when decode count is added)
■ ■ Label orientation ■■ Code type
Reading error code ()
■ Main setup
■ Trigger Input Setup
Selection method ■ ■ Level signal trigger ■ ■ One-shot signal trigger
One-shot signal ( )
trigger time
Input time ■ ■ 2 ms ■ ■ 10 ms
Input polarity ■ ■ N.O. ■ ■ N.C.
Start test mode ■ ■ Don’t start
at trigger input ON ■ ■ Start ■ ■ Reading rate ■ ■ Tact measurement
measurement
Start test mode ■ ■ Don’t start
at power ON ■ ■ Start ■ ■ Reading rate ■ ■ Tact measurement
measurement
Command Trigger ON command ( )
Trigger OFF command ( )
Baud rate ( )
Data length ■ ■ 7 bits ■ ■ Stop bits ■ ■ 1 bit ■ ■ Parity ■ ■ None
■ ■ 8 bits ■ ■ 2 bits ■ ■ Even
■ ■ Odd
RTS/CTS protocol ■ ■ Don’t use ■ ■ Use
Multi-drop link ■ ■ Don’t use
■ ■ Use ■ ■ ID No. ( )
Data addition function
(more than one can
be selected)
Trigger
input