Manual

Chapter 4 Installing the Setup Software
62
4
CODE 39 detail settings
When “CODE 39” is set for any of the 4 codes in the bar code setting and then
[Detail] is clicked, the following screen appears.
1. When “Send start/stop character (*)” is set, the BL-700 adds an * (asterisk) to
the data and sends it.
2. When “Check digit test” is set, the following appears:
When “Send check digit” is set, the BL-700 sends the data including the check
digit.
To calculate the check digit, the BL-700 uses Modulus 43.