Owner manual

KEYENCE CORPORATION. Vision System Division

‐ 13 ‐ www.keyence.com

✎Command Processing Flow

To control the controller via PLC‐Link, use the number‐specified commands.

The command processing result is stored to the

address specified as the "Command Result Address".

Refer to "Control/Data Output via Commands" in the user's manual to check the commands to use and the

formats of the number-specified commands.

Here is an example of using the PW command (command No. 24) that switches the program setting.

The following must be specified to execute the PW

command:

Command No. (24)

SD card No. (d) of the switch target program setting

Setting No. (nnn)

Specify 2‐word integer values from the data memory

specified as the "Command Address" in order.