Owner manual

360GB

KEYENCE CORPORATION. Vision System Division

‐ 3 ‐ www.keyence.com

1. Establishing the PLC-Link (Ethernet PLC-Link) [YASKAWA MP Series]

✎Checking the Global Settings of the CV-X Series

Select [Global] > [Communications & I/O] > [Network] on the controller, and then configure the network

(Ethernet) settings for the CV-X.

Select "OK" to close the "Network Settings" screen, select [Global] > [Communications & I/O] > [PLC-Link], and

then configure the PLC-Link settings.

Select "OK" to close the "PLC-Link" setting screen and then restart the controller.

Configure the network settings for CV‐X.

IP Address: 192.168.1.10

* Change the IP Address according to the

default MP Series Network Settings.

Subnet Mask: 255.255.255.0

Default Gateway: 0.0.0.0

Configure the PLC‐Link settings.

Mode: PLC- Link (Ethernet)

PLC Type: YASKAWA MP Series

IP Address: Change to 192.168.1.1

Port: Change to 1024

Resend Time (ms): 10000

* "IP Address" above indicates the one for the

KV Series that will be connected. Set an address

whose fourth number differs from that of the

"Controller IP Address" set in step 1.

Decimal Point: Fixed- point

Command Execute Event: Polling

Command Complete Address (bit): 00003

Command Address: 00100

Command Result Address: 00200

Result Output Address: 00500

Result Ready Address (bit): 00000

Result Ack Address (bit): 00001

Acknowledge result output completion:

Checked

Enable Handshake: Unchecked

[Note] The memory range that can be used

with the MP Series communication

specifications is 0 to 4095.

This section describes how to establish the PLC‐Link.

[Important] If it fails, establish a one-to-one connection between PLC and CV-X, and follow this manual to configure the settings and check

the operations. Confirm that it operates properly, and change settings if necessary.

Be careful not to use the

same IP address.