Owner manual

KEYENCE CORPORATION. Vision System Division
‐ 5 ‐ www.keyence.com
7
Restart both the CV-X Series and the YASKAWA MP Series.
If "Initializing PLC- Link..." appears on the lower left of the screen and
disappears immediately, it indicates that the link has been established
successfully.
If the link establishment has failed, the message "Initializing PLC-
Link... *" appears repeatedly, and the error message "Failed to
establish a link with the PLC" appears.
Check the settings of the CV‐X Series and YASKAWA MP Series again.
* Start the YASKAWA MP Series first, and then start the CV‐X Series.
5
On this screen, set and save the Port, IP Address, etc.
6
Send the settings to PLC using [Online] > [Write into Controller] in MPE720.
Local Port: The port specified in CV-X Series Global Settings
Set the MP Series IP Address
Save after
completing the
settings
Set to the same
number
Node IP Address: The CV-X Series IP Address
Node Port: The port specified in CV-X Series Global Settings
Connect Type: Select UDP
Protocol Type: Select Extended MEMOBUS
Code: Select BIN