Owner manual

KEYENCE CORPORATION. Vision System Division
‐ 9 ‐ www.keyence.com
2
1
3. Outputting the Measured Value/Judged Value (PLC-Link) [YASKAWA MP Series]
✎Configuring the Output Settings
Press "Select Data", and select the target data to output.
Open "Output Settings", and select "PLC- Link".
3
After finishing adding data, press "OK". Check the data to output and the data memory address.
Set the measured values/judged values to output in "Output Settings". This section describes how to assign tool
measurement values/judgment values.
(In the description, the following are output: 1 : Total Status Value, 2: T100: Pattern Search. Pattern X Position Result, 3:
T100: Pattern Search. Pattern XY Position Result, 4: T101: Area. Area Result, 5: T102: OCR. Recognized Character (String), 6:
T100: Pattern Search. Judged Value, 7: T101: Area. Judged Value, 8: Program Time, 9: Total Count)
When added, the result output unit opens.
The added output data and the list of
data memory address to which the
data is output are displayed.
The start of the data memory address
is specified in "Result Output
Address" in [Global] >
[Communications & I/O] > [PLC‐Link]
(address 500 in the above example).
See the next page for the output
format when storing in the data
memory.
Items that can be output are
categorized into "Measured Value",
"Judged Value", and "Variables".
Select an item to output from these
categories and press "Add" to add the
item.
You can change the output order of
the added items, or delete the items.