User guide
A-9
Appendix
IG-E
2 Display Screen and Output
Normally, the judgment value (P.V.) is displayed on the main display (upper level).
This section describes the judgment output and analog output status when displays other
than numbers appear on the main display.
*1 The output mode of judgment output can be set to NO (Normal Open) or NC (Normal
Close).
"4. Output mode" (page 4-19)
*2 If GTE (Overcurrent error) is displayed, all the judgment outputs are fixed to OFF.
Reference
The judgment indicator on the sensor amplifier operates in the same way as
Normally Open regardless of the output mode setting.
"3-6 Setting the Tolerance Setting Value" (page 3-11)
Display
Judgment output
*1
Analog output
NO NC
Error displays
*2
"Error displays and
corrective actions"
(page A-4)
HIGH:ON
GO :OFF
LOW:ON
HIGH:OFF
GO :ON
LOW:OFF
Analog voltage output: 5.5 V fixed
Analog current output: 3.0 mA fixed
HIGH:OFF
GO :OFF
LOW:OFF
HIGH:OFF
GO :OFF
LOW:OFF
Analog voltage output: 5.5 V fixed
Analog current output: 3.0 mA fixed
HIGH:OFF
GO :OFF
LOW:OFF
HIGH:ON
GO :ON
LOW:ON
Analog output range lower limit value
fixed
(1-5 V: 1V fixed)
HIGH:OFF
GO :OFF
LOW:ON
HIGH:ON
GO :ON
LOW:OFF
Analog output range lower limit value
fixed
(1-5 V: 1V fixed)
HIGH:ON
GO :OFF
LOW:OFF
HIGH:OFF
GO :ON
LOW:ON
Analog output range upper limit
value fixed
(1-5 V: 5 V fixed)
LASER
BANK
0
1
2
3
HI
LO
R.V.
ANALOG
HI SHIFT
ZERO SHIFT
TIMING
LO
ALIGNMENT
'T%
GO
HOLD CALC
CHECK
LASER
BANK
0
1
2
3
HI
LO
R.V.
ANALOG
HI SHIFT
ZERO SHIFT
TIMING
LO
ALIGNMENT
HOLD CALC
CHECK
GO
LASER
BANK
0
1
2
3
HI
LO
R.V.
ANALOG
HI SHIFT
ZERO SHIFT
TIMING
LO
ALIGNMENT
((((
HOLD CALC
CHECK
GO
LASER
BANK
0
1
2
3
HI
LO
R.V.
ANALOG
HI SHIFT
ZERO SHIFT
TIMING
LO
ALIGNMENT
((((
HOLD CALC
CHECK
GO