Instruction Manual

3-4
- IV Series User’s Manual (Field Network) -
Cyclic communication setting method
When setting by IV-Navigator (IV-H1)
Set the eld network settings of the sensor to
[EtherNet/IP].
1
Display the Advanced Sensor Settings
screen.
2
Select the [Environmental] tab, and then
click the [Setting] button under [Field
network].
3
Select [EtherNet/IP] in [Protocol] for the
eld network.
To enable the handshake control, check this
check box .

When the protocol is set as [Disable],
this setting item is shaded and cannot be
selected.

When the data handshake control is set as
[Enabled], the status result will not be updated
until [Result acquisition complete notice]
(“Address2, Bit0” Output Assembly) is input.
“Operating procedure of the cyclic
communication” (Page 3-26)
4
After the setting is completed, click the
[OK] button.
The system returns to the main screen in
[Program].
5
Click the [OK] button.
3
Cyclic communication