Owner manual

Chapter

Common Operations and Function Settings

E LT-9001-IM

5-15

The procedure used to set the analog output is

explained as follows.

Select [OUTPUT] from the [OUT1] or [OUT2]

screen.

The screen appears for setting the output.

Select [ANALOG+10V].

Specify the value for [ANALOG+10V] (the

upper limit of the scaling) and press the

[ENTER] button.

The change is confirmed on the screen.

Select [ANALOG-10V].

Set the lower limit of the scaling in the same

manner.

Refer to "Default Values and Setting Range"

(page 2-25) for the setting range and limitation.

• If you set the lower limit that exceeds the upper

limit, the polarity can be interchanged.

• The profile waveform voltage is output if the profile

output is ON.

"PROFILE OUT" (page 4-19), "When the Profile

Output is ON" (page 7-11)

• – 10.5V is output in judgment standby status or in

dark status.

Reference

ANALOG output

You can set any scaling on the analog output (± 10

V).

If you connect the recording instrument to the

analog output, the change of displacement can be

recorded.

Reference