Owner manual

8-18

Outputting Measured Values by Using External Synchronization

• The measured value at the instant the TIMING input turns ON is output if the measurement mode is set to

normal, auto peak hold, auto bottom hold, or auto peak-to-peak hold.

• The measured value fixed when the TIMING input turns ON is output if the measurement mode is set to peak

hold, bottom hold, peak-to-peak hold, average hold or sample hold.

The command format when [D-MODE] is set to [S1] or [S2] is shown below.

The command format when [D-MODE] is set to [S0] is shown below.

Output format

Timing Chart

E LT-9001-IM

RS-232C

Chapter