Owner manual

9-6
Specifications
Averaging time
Measurement response time
The measurement response time can be calculated with the following formula.
• Distance mode: Measurement response time = Average measurement time + Update cycle (T5) +
Internal processing time (T1)
• Profile mode: Measurement response time = Averaging response time + Average measurement time
+ Update cycle (T5) + Internal processing time (T1)
“Timing Details” (page 7-13) for
average measurement
time, update cycle (T5), and internal processing
time (T1).
Power ON reset time
This is a period of time taken to start measurement after turning on the power.
• Power ON reset time = approx. 10 sec.
The update cycle of the screen display of the microscope image and measured value differs depending on the
scan settings.
■ LT-9010 (M) ■ LT-9030 (M)
Display Update Cycle
Response Delay Time
E LT-9001-IM
Specifications
9
Chapter
Number of data for averaging Averaging time Averaging response time
2 T2x2 T2x0
4 T2x4 T2x2
16 T2x16 T2x14
* Averaging response time is used to calculate the measurement response time.
T2 is a sampling cycle ( page 7-13).
[ms
]
Profile mode
Scan width/ Displacement
FINE=OFF FINE=ON
Interval mode
OFF 116
120/2 84.5 84.5 164
120/5 108 108 192
120/10 115 116 128
250/2 169 169 323
250/5 87.1 87.1 173
250/10 113 113 96
500/2 164 164 646
500/5 151 152 327
500/10 87.1 87.1 167
1100/2 356 356 1414
1100/5 153 153 711
1100/10 164 164 359
4/1 128
[ms
]
Scan width Displacement
/Interval mode
OFF 106
120/2 174
120/4 138
120/8 115
240/2 169
240/4 169
240/8 113
400/2 142
400/4 136
400/8 164
560/2 187
560/4 187
560/8 108
4/1 128
LT-9000-M-NO9-E.qxd 10.4.8 1:59 PM ページ9-6