Instruction Manual

A-16
Appendices
7 Setting Item List
The section shows the settings that can be made for the N-410.
 Main settings
Operation mode
Trigger input setting (multi-head mode only)
 Slave settings
 Selecting a protocol
Multi-drop Link Mode
Multi-head mode BL(SR)
Multi-head mode RF
Trigger notification method
Normal (sequential) notification
Interference suppression
Interference suppression ( )
* 50 ms to 2550 ms
Broadcast notification
Read mode
Single
Multi
Data Transmission Timing
After read
After trigger OFF
Measurement method
Level One-shot
One-shot synchronization time
( ) * 100 ms to 25500 ms
Input polarity
Normal open point Normal close point
Input time constant
2 ms 10 ms
Trigger input on command
( ) *Up to 8 characters
Trigger input off command
( ) *Up to 8 characters
Q01[ ] Q02[ ] Q03[ ] Q04[ ]
Q05[ ] Q06[ ] Q07[ ] Q08[ ]
Q09[ ] Q10[ ] Q11[ ] Q12[ ]
Q13[ ] Q14[ ] Q15[ ] Q16[ ]
Q17[ ] Q18[ ] Q19[ ] Q20[ ]
Q21[ ] Q22[ ] Q23[ ] Q24[ ]
Q25[ ] Q26[ ] Q27[ ] Q28[ ]
Q29[ ] Q30[ ] Q31[ ]
Host protocol
No Handshaking PASS/RTRY ACK/NAK
Header
None STX ESC
Setting [ ] *Up to 5 characters
Delimiter
CR CR+LF ETX
Setting [ ] *Up to 5 characters
ID addition
Activate Do not activate
Add checksum
Activate Do not activate
Error code settings
[ ] *Up to 8 characters
PLC Link
Disable
Enable
DM header address [ ]
Block number 00 (0000 to
9900)
Station number [ ] (00 to 31)
Trigger input area Disable Enable