Manual

9
To connect the power supply, trigger input and
OK/NG output, you can use the wire-pin clips, as
shown below.
<Recommended terminal>
Manufacturer: Japan Solderless Terminal
Mfg.Co.
Model: VTUB-1.25
CLIPS USED FOR TERMINALS
5 mm max.
6 mm min
2.0 mm
max.
To connect the N-42/N-48 to RS-422A/RS-485
equipment, turn ON the terminator of the
equipment at both ends of the connection
[marked with * in the system configuration
diagram on p. 6] (termination resistor: 100Ω).
* The terminator switch is factory-set to OFF.
TERMINATOR SWITCH
OFF
ON