Owner's manual

ManualsBrandsKEYENCE ManualsLightingSL-V Series

111

112

113

114

115

116

117

118

119

120

4-4 Examples of Wiring

4-8

Wiring

SL-V-M-NO4-E

 When using a multi-function type cable (PNP output type cable)

Manual reset mode

The shielding wire of the PNP output type cable is connected to 0 V line in the SL-V.

Do not connect the shielding wire to +24 V line.

 When using a multi-function type cable (NPN output type cable)

Manual reset mode

The shielding wire of the NPN output type cable is connected to +24 V line in the SL-V.

Do not connect the shielding wire to 0 V line.

K1, K2 : External device (Safety relay

unit, magnet contactor, etc.)

K3 : Solid state contactor

S1 :

The switch for wait input (N.O.)

The violet wire needs to be

capped it is not used. (Open

circuit : completely

disconnected)

S2 : The switch for reset input (N.O.)

S3 : The switch for override input

(N.O.)

L1 : Muting lamp (Incandescent

lamp or LED lamp)

P1, P2 : Muting device (PZ self-

contained photoelectric sensors

<PNP output>, etc.)

M : 3-phase motor

PLC : For the monitoring use

These are NON SAFETY-RELATED system.

K2K1

PLC

OUT

P 1

P 2

(Interlock mode selection input) Pink

Cable insulation: Black

Cable insulation: Grey

Transmitter

Receiver

(Interlock-reset-ready output) Green

(+24 V) Brown

(OSSD2) White

(OSSD1) Black

(Reset input) Yellow

(EDM input) Red

(Override input) Red/black

(Muting lamp output) Yellow/black

(Muting input 1) Light blue

(Muting input 2) Light blue/black

(Wait input) Violet

(AUX output) Red

(State information output 1) Grey

(State information output 2) Grey/black

(Alert output) Pink/black

(Clear/Blocked output) White/black

(0 V) Blue

Shield

Orange/black

(Communication cable 2)

Orange

(Communication cable 1)

Brown

Blue

Black

Caution