Owner's manual

3-6 Assembling the Mounting Brackets (SL-VF/VH/VL)
3-17
Installation to a Machine
3
SL-V-M-NO3-E
1 Bracket A (1) must be installed to the unit.
2 Two screws must be used to secure bracket A to bracket B (2). (Recommended tightening torque of 0.7 N•m)
3 The bracket C must be fit with the bracket B at the opposite side of the secured with two screw at the step 2.
Then, the bracket C (3) must be moved to the direction showing the arrow in figure to fix the angle for align-
ment (4). After deciding the angle for bracket C, the bracket C must be secured with one screw (5). If you
loosen the screw (5) indicated by the procedure, you can adjust the beam axis alignment because the SL-V
can change the angle. (Recommended tightening torque of 1.2 N
•m)
1 Bracket A (1) must be installed to the unit.
2 Two screws must be used to secure bracket A to bracket B (2). (Recommended tightening torque of 0.7 N•m)
3 The bracket C must be fit with the bracket B at the opposite side of the secured with two screw at the step 2.
Then, the bracket C (3) must be moved to the direction showing the arrow in figure to fix the angle for align-
ment (4). After deciding the angle for bracket C, the bracket C must be secured with one screw (5). If you
loosen the screw (5) indicated by the procedure, you can adjust the beam axis alignment because the SL-V
can change the angle. (Recommended tightening torque of 1.2 N
•m)
Compact E-to-E mounting bracket (OP-83181)
Bracket A
(1)
Bracket B
M3
(length: 7 mm)
(2)
Bracket C
(4)
(3)
M4
(length: 12 mm)
(5)
E-to-E mounting bracket (OP-42370)
Bracket A
(1)
Bracket B
M3
(length: 7 mm)
(2)
Bracket C
(4)
(3)
M4
(length: 12 mm)
(5)