Owner's manual

5-2
Setting Each Function
Setting Items
- Setup software TM-H1 TM-Navigator User’s Manual -
Setting Items
This section describes the settings that can be configured in TM-Navigator.
Select the tabs to switch between the settings.
Reference
• Each setting can be configured for each program No.
• Send the settings to the controller after configuration is complete.
Tab Setting items Description
Reference
page
Head setting Trigger settings Configures the trigger settings that are common for Head A and Head B. 5-3
Head A Sets the measurement conditions for Head A. 5-4
Head B Sets the measurement conditions for Head B. 5-4
Master reg
Loads standard images for measurement setting and position correction. 5-6
Pos corr Head A Sets the position correction for the displayed image for Head A. 5-9
Head B Sets the position correction for the displayed image for Head B. 5-9
Measure set Set the inspection and element tools. 5-10
OUT settings Sets the OUT conditions for OUT1 to OUT16. 5-11
Common TIMING terminal Sets TIMING1 /TIMING2 for each OUT setting. 5-16
ZERO terminal Sets ZERO1 /ZERO2 for each OUT setting. 5-16
Binary output Sets binary output for each OUT setting. 5-17
Analog output
Sets the analog output conditions separately for CH1 and CH2. 5-17
Storage When storing data in the controller, select either data storage or
image storage.
5-18
Auto-send Sets auto-send for each OUT setting. 5-19
Data out timing Sets the output timing for data. 5-19
Setting list Displays the list of the settings. 5-20
Tab