Owner's manual

A-7
Appendix
Error Messages
- Setup software TM-H1 TM-Navigator User’s Manual -
OUT settings OUT name length exceeds the setting range.
Enter a name that is no longer than 20
characters long.
Set the OUT name to 20 or fewer characters.
5-11
The value for the alarm error exceeds the
setting range.
Set the value between 0 and 255.
Set the value for the alarm error between 0
and 255. 5-12
The value for offset exceeds the setting range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the offset within the displayed range.
5-12
The Tol upper limit value exceeds the setting range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the upper limit within the displayed range.
5-14
The Tol lower limit value exceeds the setting range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the lower limit within the displayed range.
5-14
The input value exceeds the setting range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the input value within the displayed range.
5-13
The display value exceeds the setting range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the display value within the displayed
range.
5-13
Common
settings
The measurement value exceeds the setting
range.
Set the value between ( ) and ( ).
* The values displayed within the parentheses
( ) vary depending on the units and the
minimum display unit.
Set the measurement value within the displayed
range.
5-17
The value for output voltage exceeds the
setting range.
Set the value between -10.500 and 10.500.
Set the value for output voltage between
-10.500 and 10.500. 5-17
Set the span value between -10 and 10. Set the value again to meet the input conditions. -
The same value cannot be set for
measurement.
Set different values for the input values.
5-17
The amount of storage data exceeds the setting
range.
Set the value between 1 and 65536.
Set the amount of storage data between 1
and 65536. 5-18
Item Display contents Remedy
Reference
page