User's Manual

User M a nua l
( This product will turn off when com bined; turn on when separated.)
1. When separated, t he receiver and t he transm itt er proceeds t he
linking- code procedure and t hen follows one long & one short
beeps, t he LED on bot h receiver side and t ransm it t er side will flash,
then you can begin t o use them . I f t hey cannot flash, it m eans the
linking- code procedure is failed. The receiver sounds continuously
short ‘‘Beep’’ ( B─ B─ B─ • • • ) per sound. Please repeat t his
operation st ep again.
2. Under norm al operation, when t he effective dist ance ( about 2
m eters) between the receiver and t he transm itt er is exceeded, t he
receiver’s alarm will alert cont inuously t hree ‘‘Beep’’ ( BBB─
BBB) per sound.
3. When t he dist ance bet ween the receiver and t he t ransm it t er is
short er than t he effect ive dist ance, t he alarm will st op alerting
im m ediately.
I m por t ant inform at ion
1. When t urn on t he product , t he dist ance between t he receiver and
the transm it t er m ust exceed 30cm t o proceed t he linking- code
procedure.
2. To extend batt ery life, be sure to turn off the product ( com bined
status) when it is not in use.
3. The effect ive dist ance m ay be dim inished by environm ental
condition such as walls, m et al object s, relative hum idit y and other
radio signals. Try t o get rid of it or m ove away from the
int erference.
4. Keep t his product away from water and avoid being crashed.
Tr ouble shoot ing
1. Change the batt ery as soon as possible as follow condition：
( Lit hium batt ery CR2032)
● LED light becomes dim.
● The effective distance becomes shorter than normal distance.
● Alert sounds weak.
2. Check for any nearby source of int erference. Try t o get rid of it or
m ove away from t he source.
3. I f none of t he above works, return unit t o factory as per warrant y.
Do not att em pt t o repair it by yourself.