User manual

4 Making Measurements
98 Agilent 1000 Series Oscilloscopes User’s Guide
Displaying Automatic Measurements
You can use the [Measure] key to display automatic measurements. The
oscilloscope has 22 automatic measurements and a hardware frequency
counter (see “Voltage Measurements” on page 100 and “Time
Measurements” on page 103).
To display an automatic measurement
1 Press [Measure].
2 In the Measure menu, press Source to select the input channel on which
to make the automatic measurement.
3 Press Voltage (for voltage measurements) or Time (for time
measurements) and turn the entry knob to select the desired
measurement.
4 Then, either push the entry knob or press Voltage or Time again to
add the measurement to the bottom of the display.
If the measurement result is displayed as "*****", the measurement cannot
be performed with the current oscilloscope settings.
Figure 39 [Measure] Key
Menu
Zoom
Cursors
Measure
Acquire
Display
Help
Utility
Print
Save
Recall
Default
Setup
Auto-
Scale
Run
Stop
Single
Push
Push
Push
for Zoom
to Zero
for 50%