User manual
Table Of Contents
- Agilent U1231A, U1232A, and U1233A Handheld Digital Multimeter
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Making Measurements
- 3 Multimeter Features
- 4 Multimeter Setup Options
- Using the Setup Menu
- Setup Menu Summary
- Setup Menu Items
- Changing the variation count
- Enabling and changing the Smooth refresh rate
- Enabling and changing the voltage alert level
- Changing the beep frequency
- Changing the auto power-off (APO) timeout
- Changing the LCD backlight timeout
- Adjusting the LCD backlight intensity
- Enabling the LED flashlight timeout
- Adjusting the LED flashlight intensity
- Changing the minimum measurable frequency
- Changing the continuity test alerts
- Changing the power-on greeting tone
- Resetting the Setup items
- Changing the scale conversion value
- Enable the AC/DC mV measurement
- Enable open continuity test by default
- Changing the temperature unit
- 5 Characteristics and Specifications
4 Multimeter Setup Options
Setup Menu Items
84 U1231A/U1232A/U1233A User’s Guide
Setup Menu Items
Changing the variation count
This setting is used with the Auto Hold- Log function (see
page 72). When the variation of the measured value exceeds
the value of the variation count, the Auto Hold- Log function
will be ready to trigger.
Use this Setup item to change the variation count for the
Auto Hold- Log function between 1 to 999 counts.
Figure 4-1 Changing the variation count
Parameter Range Default setting
AutoHold (001 to 999) counts 50 counts
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press