User manual
Table Of Contents
- Agilent U1231A, U1232A, and U1233A Handheld Digital Multimeter
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Making Measurements
- 3 Multimeter Features
- 4 Multimeter Setup Options
- Using the Setup Menu
- Setup Menu Summary
- Setup Menu Items
- Changing the variation count
- Enabling and changing the Smooth refresh rate
- Enabling and changing the voltage alert level
- Changing the beep frequency
- Changing the auto power-off (APO) timeout
- Changing the LCD backlight timeout
- Adjusting the LCD backlight intensity
- Enabling the LED flashlight timeout
- Adjusting the LED flashlight intensity
- Changing the minimum measurable frequency
- Changing the continuity test alerts
- Changing the power-on greeting tone
- Resetting the Setup items
- Changing the scale conversion value
- Enable the AC/DC mV measurement
- Enable open continuity test by default
- Changing the temperature unit
- 5 Characteristics and Specifications
4 Multimeter Setup Options
Setup Menu Items
86 U1231A/U1232A/U1233A User’s Guide
Enabling and changing the voltage alert level
This setting is used with the multimeter’s voltage alert (see
page 10). The multimeter will start beeping periodically once
the measured voltage exceeds the level set, regardless of
polarity.
Use this Setup item to enable or disable the voltage alert,
and to change the voltage alert level between 1 to 660 V.
Figure 4-3 Enabling and changing the voltage alert level
Parameter Range Default setting
V(oltage Alert) (1 to 660).(d or E) V
030.d V
(disabled)
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press