Datasheet

Page 30
Find us at www.keysight.com
Keysight Wedge electrical
characteristics
Operating
voltage
< 40 Vdc + peak ac
Operating
current
0.5 A maximum
Capacitance
between
contacts
2 pF typical (all except
Keysight-E2643A/44A)
4.33 pF typical at 1 MHz
(Keysight-E2643A/44A)
Self-inductance 15 nH typical (all except
Keysight E2643A/44A)
37 nH typical at 1 MHz
(Keysight E2642A/44A)
Cross coupling –31 dB typical at 100 MHz
(Keysight E2643A/44A)
Contact
resistance
< 0.1 Ω
Ordering information
E2613A 0.5 mm Wedge probe adapter,
3 signal, qty 1
E2614A 0.5 mm Wedge probe adapter,
8 signal, qty 1
E2643A 0.5 mm Wedge probe adapter,
16 signal, qty 1
E2615A 0.65 mm Wedge probe adapter,
3 signal, qty 1
E2616A 0.65 mm Wedge probe adapter,
8 signal, qty 1
E2644A 0.65 mm Wedge probe adapter,
16 signal, qty 1
10072A SMT kit for 10070 probe family
10075A 0.5 mm IC clip kit
IC clip kits
An inexpensive solution for probing
fine-pitch ICs, the 10072A SMT kit
includes 10 IC clips and 2 dual-lead
adapters that connect the clips directly to
10070-family probes.
The 10075A 0.5-mm IC clip kit is ideal
for connecting to ICs as fine as 0.5 mm.
The clip body allows many clips to be
mounted side-by-side. The kit includes
four 0.5-mm IC clips and two dual-lead
adapters that connect the IC clips directly
to 10070-family probes.
– Easy connection to surface mount
ICs
– Safe, with no chance of shorting
– Mechanically non-invasive contact
– 3-, 8-, and 16-signal versions
– Supports 0.5 and 0.65-mm
– TQFP and PQFP packages
Problem-free probing
The Keysight wedge probe adapter
eliminates many of the frustrations
associated with probing surface mount
components. If you have ever accidentally
shorted IC pins together, experienced
electrical and/or mechanical problems
with soldering small wires onto leads, or
gotten frustrated juggling multiple probes
while you are trying to operate your
scope, the Wedge was designed with you
in mind.
Make the inaccessible
accessible
When you use the Wedge, you do not
have to worry about shorting IC pins
together on a delicate component–or on
an irreplaceable prototype. The Wedge
is easy to insert and it stays put. There is
no need to solder small wires onto leads.
The Wedge is mechanically non-invasive,
so you will not damage the legs of the
IC. Instead, you will have easy access to
hard-to-reach components.
Electrical reliability
The Wedge makes two contact points
with each leg of the IC. This redundant
physical connection increases the
electrical reliability of the connection. The
Wedge’s low capacitance and inductance
provides superior performance to many
other alternatives.
The Wedge probe adapter connects
directly to 1145A/1155A active probes
and the dual lead adapter provided with
the 1160A-65A passive probe family and
N2877A/N2879A accessory kits for use
with N287xA Series passive probes.
Wedge Probe Adapters