Datasheet
07 | Keysight | 6800C Series AC Power Source/Analyzers, 375-1750 VA - Data Sheet
For a sine wave with a resistive load at 0 ° to 40 °C, within an output frequency range of 45 Hz to 1000 Hz, and in AC coupled mode
after a 30 minute warm-up unless otherwise noted.
Specifications (continued)
1. Product may be operated between DC and 45 Hz subject to certain deratings. Measurements may be extended to 4.5 Hz at full accuracy only by selecting a
digitization rate of 250 μ seconds per point. Frequency content of the measured signal must be limited to 4 kHz or less to avoid aliasing effects.
2. 2Select low measurement range for improved accuracy (10:1) for lower power measurements.
Measurement accuracy (at 25 ° ± 5 °C) 6811C 6812C 6813C
Rms. voltage (45 - 100 Hz) 0.03% + 100 mV
1
0.03% + 100 mV
1
0.03% + 100 mV
1
DC voltage 0.05% + 150 mV
1
0.05% + 150 mV
1
0.05% + 150 mV
1
RMS current (45 - 100 Hz)
2
High range 0.05% + 10 mA 0.05% + 10 mA 0.05% + 10 mA
Low range 0.05% + 1.5 mA 0.05% + 1.5 mA 0.05% + 1.5 mA
Power (VA) (45-100 Hz)
2
High range 0.1% + 1.5 VA + 12 mVA/V 0.1% + 1.5 VA + 12 mVA/V 0.1% + 1.5 VA + 12 mVA/V
Low range 0.1% + 1.5 VA + 1.2 mVA/V 0.1% + 1.5 VA + 1.2 mVA/V 0.1% + 1.5 VA + 1.2 mVA/V
Power (watts) (45-100 Hz)
2
High range 0.1% + 0.3 W + 12 mW/V 0.1% + 0.3 W + 12 mW/V 0.1% + 0.3 W + 12 mW/V
Low range 0.1% + 0.3 W + 1.2 mW/V 0.1% + 0.3 W + 1.2 mW/V 0.1% + 0.3 W + 1.2 mW/V
Frequency 0.01% + 0.01 Hz 0.01% + 0.01 Hz 0.01% + 0.01 Hz
Power factor 0.01 0.01 0.01
Current magnitude (low range)
Fundamental 0.03% + 1.5 mA 0.03% + 1.5 mA 0.03% + 1.5 mA
Harmonics 2-49 0.03% + 1 mA + 0.2%/kHz 0.03% + 1 mA + 0.2%/kHz 0.03% + 1 mA + 0.2%/kHz
Current magnitude (high range)
Fundamental 0.05% + 5 mA 0.05% + 5 mA 0.05% + 5 mA
Harmonics 2-49 0.05% + 3 mA + 0.2%/kHz 0.05% + 3 mA + 0.2%/kHz 0.05% + 3 mA + 0.2%/kHz
Supplemental characteristics
(Non-warranted characteristics determined
by design and useful in applying the product)
6811C 6812C 6813C
Average programming accuracy
(% of output + offset) rms current 1.2% + 50 mA 1.2% + 50 mA 1.2% + 50 mA
Average programming resolution
rms voltage 125 mV 125 mV 125 mV
DC voltage 250 mV 250 mV 250 mV
Overvoltage programming (OVP) 2 V peak 2 V peak 2 V peak
rms current 2 mA 4 mA 4 mA
Peak current 12.5 mA 25 mA 25 mA
Output frequency 10 μHz 10 μHz 10 μHz
Phase N/A N/A N/A