Datasheet

10 | Keysight | AC6800B Series Basic AC Power Sources - Data Sheet
Model AC6801B AC6802B AC6803B AC6804B
Common interface specifications
Software protocol IEEE Std 488.2-1992
Command language SCPI Specification 1999.0
Save/recall states Save and recall up to ten instrument states in non-volatile memory
Accessories included
Power cord 1 standard power cord
1
Length: Approx. 2.5 m
Not included Not included Not included
Ferrite core 1
Cable tie 1
Analog programming interface (Option AC68BALGU)
Input Maximum voltage ±15 V
Connector BNC
Impedance 10 kΩ ± 5% (unbalanced)
Isolation voltage ±100 Vmax
EXT-AC mode
2
Input voltage range 0 V to +10 V (DC)
Voltage amplification ratio
(155 V/310 V range)
15.5x/31x
(Outputs an AC voltage of 0 V to 155 V/0 V to 310 V with respect to a DC voltage input of 0 V to 10 V)
Frequency setting range 40 Hz to 500 Hz
Other output rating
specifications
Same as the specifications of the output rating for AC mode
EXT-DC mode Input voltage
range
When ATT is OFF 0 V to ±2.19 Vpeak (0 V to 1.55 Vrms sine wave)
When ATT is ON 0 V to ±10 V (DC)
Input frequency
range
When ATT is OFF
3
40 to 500 Hz (sine wave)/40 to 100 Hz (rectangular wave)/DC
Frequency
response
When ATT is OFF –0.3 dB at 500 Hz with respect to 55 Hz (typical)
Voltage
amplification ratio
(155 V/
310 V range)
When ATT
is OFF
100x/200x
(Outputs an AC voltage of 0 to 155 V/0 to 310 V with respect to a AC voltage input of 0 to 1.55 V)
When ATT
is ON
21.9x/43.8x
(Outputs a DC voltage of 0 to ±219 V/0 to ±438 V with respect to a DC voltage input of 0 to ±10 V)
Other output rating
specifications
Same as the specifications of the output rating for DC mode
Output voltage distortion ratio
4
Main specifications + 0.5% or less
Output voltage temperature coefficient Main specifications + 200 ppm/°C (typical)
Insulation
resistance
Between input (BNC) and chassis, input (BNC) and output 500 V DC, 30 MΩ or more
Withstand
voltage
Between input (BNC) and chassis, input (BNC) and output 500 V AC for 1 minute
1. Based on country of use; power cords for Continental Europe, United States/Canada or China included. For other countries, applicable power cord can be
selected
2. Set ATT to ‘ON’ in EXT-AC mode at all times
3. The measurable range of voltage, current, and power is DC and 40 to 500 Hz. To improve measurement stability of an AC output, set the frequency to match
the frequency of the external input signal
4. When DC voltage is applied for EXT-AC mode or when a sine wave with distortion ratio of 0.1% or less is applied for EXT-DC mode
Supplemental Characteristics continued