Datasheet

09 | Keysight | AC6800B Series Basic AC Power Sources - Data Sheet
Model AC6801B AC6802B AC6803B AC6804B
Common
Isolation to ground 310 Vrms or 438 VDC
Insulation resistance
(Between input and chassis, output and
chassis, input and output)
500 Vdc, 30 MΩ or more
Withstand voltage
(Between input and chassis, output and
chassis, input and output)
1.5 kV AC for 1 minute
Earth continuity 25 A AC, 0.1 Ω or less
Electromagnetic compatibility (EMC)
1
Complies with the requirements of the following directive and standards
EMC Directive 2004/108/EC
EN 61326-1
Under following conditions: The maximum length of all connecting cables and wires to the unit is less than 3 m.
Safety Complies with the requirements of the following directive and standards
Low Voltage Directive 2006/95/EC
EN 61010-1
Class I
Pollution Degree 2
Environment
Operating environment Indoor use, Overvoltage Category II
Operating temperature and humidity
range
0 to 40 °C (32 to 104 °F), 20% to 80% R.H. non-condensing
Storage temperature and humidity
range
–10 to 60 °C (14 to 140 °F), 90% or less R.H. non-condensing
Altitude Up to 2000 m
Acoustic noise < 70 dbA
Physical
Dimensions (Depth includes
Barrier Block Safety Cover)
428 × 128 × 370 mm
16.9 x 5.0 x 14.6”
428 × 128 × 370 mm
16.9 x 5.0 x 14.6”
428 × 128 × 581 mm
16.9 x 5.0 x 22.9”
428 × 262 × 611 mm
16.9 x 10.3 x 24”
Weight Approx. 8 kg (17.64 lb) Approx. 11 kg (24.25 lb) Approx. 15 kg (33.07 lb) Approx. 31 kg (68.34 lb)
Input terminal IEC 320 inlet M4 terminal block M6 terminal block M6 terminal block
Output terminal M4 terminal block M4 terminal block M4 terminal block M6 terminal block
LAN interface
Hardware IEEE 802.3 100Base-TX or 10Base-T Ethernet
Complies with LXI Specification version 1.4 Class C
IPv4, RJ-45 connector2
Communication protocol VXI-11, HiSLIP, or SCPI-RAW
Program message terminator VXI-11 and HISLIP: LF or END during reception, LF + END during transmission
SCPI-RAW: LF during reception, LF during transmission
USB interface
Hardware Complies with USB 2.0; Data rate: 12 Mbps (full speed)
Program message terminator LF or EOM during reception, LF + EOM during transmission
Device class Complies with the USBTMC-USB488 device class specifications
GPIB interface (Option AC68GPBU)
Hardware Complies with IEEE Std 488.1-1978
SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT1, C0, E1
Program message terminator LF or EOI during reception, LF + EOI during transmission
Primary address 1 to 30
1. Only on models that have CE marking on the panel. AC68xx models will not be in compliance with EMC limits unless the ferrite core is attached on the
load wires
Supplemental Characteristics continued