Datasheet

Find us at www.keysight.com Page 15
Performance characteristics (continued)
Trigger type selections
9. The pattern must have stabilized for a minimum of 5 ns to qualify as a valid trigger condition.
EDUX1052A/EDUX1052G
DSOX1202A/DSOX1202G
DSOX1204A/DSOX1204G
Edge
Trigger on a rising, falling, alternating or either edge of any source
Pattern/state
Trigger when a specified pattern/state on any combination inputs is entered
9
Pulse width
Trigger on a pulse of a selected channel with a time duration that is ‘less than a value,’
‘greater than a value’ or ‘inside a time range’
Range minimum: 10 ns, 10 s max
Setup and hold
Not available
Trigger and clock/data setup and/or hold time violation.
Setup time can be set from
–7 ns to 10 s.
Hold time can be set from 0 s to 10 ns
Rise/fall time
Not available
Trigger on rise-time or fall-time edge-speed violations
(< or >) based on
a user-selectable threshold and time
setting range between 5 ns and 10 s
Video
Trigger on all lines or individual lines; odd/even or all fields from the composite video; or
broadcast standards (NTSC, PAL, SECAM, and PAM-M)
I
2
C
Trigger at a start/stop condition or user-defined frame with address and/or data values. Also,
trigger on missing acknowledge, restart, EEPROM read and 10-bit write
RS-232/422/485/UART
Trigger on Rx or Tx start bit, stop bit, data content or parity error
SPI
Not available
Trigger on SPI (Serial Peripheral Interface) data
pattern during a specific framing period. Supports
positive and negative chip select framing as well
as clock idle framing.
Supports MOSI or MISO (4-
channel models)
data as half duplex data
CAN
Not available
Trigger on CAN (controller area network) version
2.0A and 2.0B signals. Trigger on the start of
frame (SOF) bit
, remote transfer request frame ID
(RTR), data frame ID (~RTR), remote or data
frame ID, data frame ID
+ data, error frame, all
errors, acknowledge error
, or overload frame.
LIN
Not available
Trigger on LIN (Local Interconnect Network) sync
break, frame ID
, frame ID + data, parity error, or
checksum error