Datasheet

Find us at www.keysight.com Page 16
Performance characteristics (continued)
Serial protocol analysis/decode (standard)
EDUX1052A/EDUX1052G
DSOX1202A/DSOX1202G
DSOX1204A/DSOX1204G
I
2
C
Baud Rate: Up to 3.4 Mbps
Address size: 7
-bit or 8-bit
Number of time
-correlated decode traces:
One plus protocol lister/table
Baud rate: Up to 3.4 Mbps
Address size: 7
-bit or 8-bit
Number of time
-correlated decode traces:
One plus protocol lister/table
UART/RS232
Baud Rate: 100 bps to 10 Mbps
Number of bits: 5 to 9
Bit order: lsb or msb
Decode formats: Hex, binary, or ASCII
Number of time
-correlated decode traces:
Two (Tx and Rx) plus protocol lister/table
Baud rate: 100 bps to 10 Mbps
Number of bits: 5 to 9
Bit order: lsb or msb
Decode formats: Hex, binary, or ASCII
Number of time
-correlated decode traces:
Two (Tx and Rx) plus protocol lister/table
SPI
10
Not available
Baud rate: Up to 25 Mbps
Chip select: low, high, or time
-out
Number of time
-correlated decode traces on 4-channel models:
Two (MISO and MOSI) plus protocol lister/table
Number of time
-correlated decode traces on 2-channel models:
One (Data) plus protocol lister/table
CAN
Not available
Baud rate: 10 kbps to 5 Mbps
Standard: “Classic” CAN 2.0
Real
-time totalizer: Number of frames, number of error frames,
number of overload frames, bus load (%)
Number of time-correlated decode traces: One plus protocol lister/table
LIN
Not available
Baud rate: 2.4 kbps to 625 kbps
Standards: LIN 1.3
and 2.x
Number of time-correlated decode traces: One plus protocol lister/table
10. 4-channels models (DSOX1204A or DSOX1204G) recommended for 4-wire SPI measurement applications.
Waveform measurements
All Models
Cursors
Single cursor accuracy: ± [DC vertical gain accuracy + DC vertical offset accuracy + 0.25% full scale]
Dual cursor accuracy: ± [DC vertical gain accuracy + 0.5% full scale]
Units: Seconds(s), Hz (1/s), phase (degrees)
Automatic measurements
Select up to 4 continuously updated measurements from a list of 32 available amplitude, timing, and count measurements
Cursors track last selected measurement
Use default (relative/%) or customizable measurement threshold levels (absolute or relative)
Measurements automatically gated by zoom window
Vertical/amplitude measurements (14):
Peak
-to-peak, maximum, minimum, amplitude, top, base, overshoot, preshoot, average-N cycles, average-full screen,
DC RMS-N cycles, DC RMS-full screen, AC RMS-N cycles, AC RMS-full screen (standard deviation)
Timing measurements (14):
Period, frequency, counter, +width,
-width, +duty cycle, -duty cycle, bit rate, rise time, fall time,
delay, phase, X at min Y, X at max Y
Count measurements (4):
+pulse count, -pulse count, rising edge count, falling edge count
Snapshot:
Performs 24 parametric measurements once (not updated) on a single source (ch1, ch2, ch3, or ch4) one time
Automatic measurement logging: Available via BenchVue BV0004B (standard)