Datasheet

08 | Keysight | InniiVision Oscilloscope Probes and Accessories - Data Sheet
InniiMax Active Probes
and Accessories
1130A-34A InniiMax
high-performance active probe
system
– 1.5 - 7 GHz InniiMax probe system
– InniiMax probe amplier supports
both differential- and single-ended
measurements for a more
cost-effective solution
– Unrivaled InniiMax probing
accessories support browsing,
solder-in, and socketed use models at
the maximum performance available
– Compatible with 3000 X-, 4000 X-,
6000 X-, 5000, 6000, and 7000 Series
oscilloscopes (except for 6000 Series
100-MHz models)
The InniiMax 1130A Series probe
amplier is a perfect complement to the
InniiVision 1 GHz or higher bandwidth
models. Its bandwidth, extremely low
input capacitance (0.32 pF), high
common mode rejection, and patented
resistor probe tip technology provide ultra
low loading of the DUT and superior signal
delity. Keysight’s innovative InniiMax
1130A Series differential probe is the
easiest-to-use, and highest performance
probing system available for high-speed
digital design, and represents a new
industry standard for accuracy, exibility,
and reliability. Designers can achieve full
system bandwidth in conjunction with
InniiVision Series oscilloscopes even
when manually browsing with the probe or
making hands-off measurements.
Optional solder-in probe heads and
solder-in sockets, as well as browser
conguration provide full bandwidth at the
probe tip.
Operating characteristics
Probe bandwidth (–3 dB) 1134A: > 7 GHz
1132A: > 5 GHz
1131A: > 3.5 GHz
1130A: > 1.5 GHz
Rise and fall time
(10 to 90%)
1134A: 60 psec
1132A: 86 psec
1131A: 100 psec
1130A: 233 psec
Input capacitance Cm = 0.1 pF Cm is between tips
Cg = 0.34 pF Cg is ground for each tip
Cdiff = 0.27 pF Differential mode capacitance = Cm + Cg/2
Cse = 0.44 pF Single-ended mode capacitance = Cm + Cg
Input resistance Differential mode resistance = 50 kΩ ± 2%
Single-ended mode resistance = 25 kΩ ± 2%
Input dynamic range ±2.5 V
Input common mode range ±6.75 Vdc to 100 Hz; ±1.25 V > 100 Hz
Maximum signal slew rate 18 V/ns when probing a single-ended signal
30 V/ns when probing a differential signal
DC attenuation 10:1 ± 3% before calibration on oscilloscope
10:1 ± 1% after calibration on oscilloscope
Offset range ±12.0 V when probing single-ended signal
Maximum input voltage 30 Vpeak, CAT I
ESD tolerance > 8 kV from 100 pF, 300 Ω HBM
Maximum number of probes
supported by
3000 X-/5000/6000/7000 Series
2
Maximum number of probes
supported by 4000 X- and 6000
X-Series
4
Keysight 1130A InniiMax probe offers you the highest performance available for measuring differential and
single-ended signals