User's Manual Network Adapter USA-19,USA-19Q,USA-19Qi

7.1.cx.02 - Modem/Cell Phone PPP Setup
Before you begin...
This Configuration Example shows you how to configure a dial-up internet connection (aka PPP
connection) via the Network System Preference. In this example, a modem or cell phone is
connected to a Keyspan serial port and the Network System Preference is told to communicate
with that Keyspan serial port.
Before you begin, please make sure that you have done the following:
1. installed the Keyspan serial port hardware and software
2. connected the Modem/Cell Phone hardware to a Keyspan serial port
If you have not performed any of the steps mentioned above, please do so before proceeding.
Step 1 - Check the Keyspan Serial Assistant
Before proceeding, you should check to see if the Keyspan serial port is installed correctly.
To do this, open the
Keyspan Serial Assistant
(located in your Applications folder). When you
open the
Keyspan Serial Assistant
, you will see a window similar to the one shown below:
the Keyspan Serial Assistant window
(continued on next page...)
Keyspan:USB Serial Adapter for Mac OS X-v2.x User Manual
This User Manual applies to the Keyspan USB Serial Adapter Software for Mac OS X.
Rev 05jul15 Page 22