Instructions / Assembly

11 12
 The operation panel of the remote control is subject to the importing country.
IV. Product Installation Method
 Installation method
The product can be used directly after unpacking (without installation).
 Method of use of function buttons
1. Plug in the power, the buzzer sends " beep-beep " sound, and the system enters standby
mode; if there is no button operation within one minute after any light and digital tube turn
on, the light and the digital tube turn dark (33% brightness); if the button is operated, the
light and the digital tube become brighter.
2. Power on/off button:
a. In power on state, press this button to send a long Bi- sound, and the device turns off
and enters standby mode.
b. In power off state, press the Power on/off button, and all LED lights flash sequentially
clockwise in three seconds; then it enters default working state, except the timing,
sleep and natural mode. (Note: The device enters default working state only when the
power cord is unplugged for the first time; if the device is turned off and the power cord
isn’t unplugged, it will enter last state when the Power on/off button is pressed) Below
are the default working states:
- Normal mode by default after turning on, no LED display;
- Digital tube displays ambient temperature, "C" indicator turns on;
- Blade indicator is off;
- Cooling/humidification are off;
- Start at medium level, turn to level low after three seconds;
- Timer function is off, indicator turns off;
3. Speed button
In power on state, press the Speed button to switch among low, medium and high speeds.
4.
5.
Cooling/humidify button
In power on state, press this button to switch on/off cooling/humidify , and the
corresponding indicator displays its function
Timing button
a. After turning on, the timer is turned off by default, and the digital tube displays
ambient temperature; when the button is first pressed, the “H” indicator turns on,
and the timer is set to 0.5h; the time increases by 0.5h when the button is pressed
every time, and the timer can be set up to 8.0 hours; if the button is pressed again,
the digital tube displays 00, and the timer turns off; press the button again to repeat
the cycle; within 2-3S after setting the time, it displays the ambient temperature, and
"C "indicator turns on
b. In timer state, the last 0.5 hour counts down, the digital tube displays remaining time
(not ambient temperature), and enters standby state after reaching specified time.
6. Mode button
In power on state, press this button to switch the working mode among normal, natural,
sleep and smart.
- Normal: running at a constant speed setting.
- Natural: running at changing wind speed; in natural wind state, LED only displays the set
level, which doesn’t change with the wind speed, same as natural wind.
- Sleep: running at natural wind, decreasing by one level every 30 minutes; in sleep wind
On/Off
Speed
Mode
Timing
Swing
Cooling/Humidify