User Guide

How to make a duplicate
keycard/keyfob
1. Place the Keysy remote on top of the
included rewritable keyfob.
2. Make sure the LED is centered on top of
the rewritable keyfob.
3. Press the previously programmed button
that you wish to duplicate 5 times.
4. The RED LED will briefly blink as the
rewritable keyfob is being programmed.
5. After a short period of time, the Keysy
remote will blink GREEN 3 times
(success) or RED 3 times (failure).
6. If programming fails, flip over the rewritable
keyfob and repeat steps 1- 5 above.
7. Once successful, the rewritable keyfob can
be used just like the original keycard/keyfob.
When reprogramming a rewritable keycard/
keyfob it may be necessary to reformat it first.
Keysy Remote Compatibility
Due to inconsistencies between manufacturers,
Keysy remote does not work on every RFID
reader. In the case where Keysy remote does
not work with a specific RFID reader it can still
be used to make a duplicate copy of a keycard/
keyfob onto the included rewritable keyfob.
Battery
Only program the Keysy remote with a fresh
CR2032 battery. If programming fails after
repeated tries please replace the battery and
retry the programming sequence.
Battery replacement
Reformatting rewritable
keycards/keyfobs
1. Place the Keysy remote, with the LED centered,
on top of the rewritable keycard/keyfob.
2. Press the following sequence (you should
see 3 long green flashes after it’s been
reformatted): .
3. You can now try programming the keyfob/
keycard by following the How to make a
duplicate keycard/keyfob section.
Battery warning
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace only with 3V CR2032 coin cell
battery.
• DO NOT recharge, disassemble, heat
above 212° (100°C) or incinerate.
Model KF-001
www.tinylabs.io/keysy
NOTICE: To comply with FCC and CE rules all modifications to the
equipment within are expressly prohibited, except for replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Tiny Labs Inc hereby declares that this wireless device is in compliance
with the essential requirements and other relevant provisions of CE the
RE Directive.
Use of this product constitutes acknowledgement of the terms set forth
below:
The Keysy™ RFID Duplicator is intended as a tool to conveniently store
multiple radio frequency identification (RFID) keys for later recall and use.
Tiny Labs, Inc. makes no claims that the user of the product will experience
any increased level of security by using Keysy™. The user of this product
does so at their own risk. Therefore the user of this product releases and
forever discharges Tiny Labs, Inc., and their stockholders, successors and
assigns, agents, attorneys, and representatives from any and all claims,
demands, debts, liabilities, actions, causes of action, suits, contract
controversies, obligations, and judgments, whether in law or equity, arising
out of or relating to the use and operation of the Keysy™ RFID Duplicator.
Before going through these steps Keysy remote must be programmed using the previous section.
6126 Keysy_instructions_TL_final.indd 2 25/1/19 1:23 pm