User's Manual

10
AP
OR100 Series
User Manual
Outdoor Installation of Radios
KeyWest APOR100 Series products are all outdoor radios installed in one of the following
methods:
1. Pole/Tower Mount: Radio installation kit includes two metal hose clamps to support
pole sizes from 30mm to 60mm diameter.
2. Wall Mount: With optional wall mount kit, radios can be installed on the side of the
building or a structure without any obstruction to the radio antenna.
Typical Deployment.
Certified Antenna Gain & Tx Power Values
Antennas shown in the table below or antennas of the same type with lower gain are approved for
KeyWest Radio deployments.
Operating Frequency Band 5150 – 5250 MHz
It is the responsibility of the installer to ensure that radios operating in the band 5150-5250 MHz
are installed so that they do not exceed 21 dBm EIRP at any elevation angle above 30 degrees as
measured from the horizon, as specified in FCC rule 47 CFR Part 15.407 (a)(1)(i).
This compliance can be achieved through proper selection of radio with antenna, angle of
elevation, and Tx power control to provide reasonable protection for co-channel NGSO/MSS
operations.
As shown in the typical deployment above, the highest antenna gain from the horizon above 30
degree for antenna model 1 & 2 is below. For more detail information, please refer to antenna
specifications.