Instruction Manual

Instruction Manual
10
KGS Corporation
1.6 How to set a braille tape
A braille tape is not set inside the body of BL-1000 LINK before shipment. Please
set an attached braille tape for exclusive use for print by the following procedures.
Procedure for setting a tape
1. Connect BL-1000 LINK to AC adaptor, turn
on the power supply switch.
It shortly sounds like a mechanical movement to
send a braille tape to the exit, and slightly long
beep sounds at three times. This means to be out
of a braille tape.
2. Open a cover for a braille tape, set a whole
braille tape with a paper case vertically in the
center between partitions in the body.
Set a paper case which side is higher than
other one, so as to be in the left side in the tape
holder place. (left side is close to the tape
entrance)
3. Remove a seal which fixes an edge of a braille
tape on a roll.
Insert an edge of a braille tape into the entrance
of printing section, and insert it by the place to
meet an inside roller of printing section.
①
②